esphome-mitsubishi.yaml

---
substitutions:
  name: esp32-attic-big-window-heatpump
  friendly_name: esp32-attic-big-window-heatpump

esphome:
  name: ${name}

esp32:
  board: esp32doit-devkit-v1
  # Boards tested: ESP-01S (ESP8266), Wemos D1 Mini (ESP8266); ESP32 Wifi-DevKit2

wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password

# Note: if upgrading from 1.x releases of esphome-mitsubishiheatpump, be sure
# to remove any old entries from the `libraries` and `includes` section.
#libraries:
  # Remove reference to SwiCago/HeatPump

#includes:
  # Remove reference to src/esphome-mitsubishiheatpump

# Enable logging
logger:
  # ESP8266 only - disable serial port logging, as the HeatPump component
  # needs the sole hardware UART on the ESP8266

mqtt:
  broker: !secret mqtt_broker
  username: !secret mqtt_username
  password: !secret mqtt_password
  client_id: ${name}
  #discovery: false
  topic_prefix: esphome/${name}

# Enable Home Assistant API
api:
  encryption:
    key: "123"

ota:
  - platform: esphome
    password: "123"

# Enable Web server.
web_server:
  port: 80

  # Sync time with Home Assistant.
  #time:
  #- platform: homeassistant
  #  id: homeassistant_time

# Text sensors with general information.
text_sensor:
  # Expose ESPHome version as sensor.
  - platform: version
    name: ${name} ESPHome Version
  # Expose WiFi information as sensors.
  - platform: wifi_info
    ip_address:
      name: ${name} IP
    ssid:
      name: ${name} SSID
    bssid:
      name: ${name} BSSID

# Sensors with general information.
sensor:
  # Uptime sensor.
  - platform: uptime
    name: ${name} Uptime

  # WiFi Signal sensor.
  - platform: wifi_signal
    name: ${name} WiFi Signal
    update_interval: 60s

external_components:
  #- source: github://geoffdavis/esphome-mitsubishiheatpump
  #- source: "github://geoffdavis/esphome-mitsubishiheatpump@31ed3068fcf0713873b157e28d0d36248a352d83"
  - source: github://echavet/MitsubishiCN105ESPHome

climate:
  #- platform: mitsubishi_heatpump
  - platform: cn105
    name: "${friendly_name}"
    supports:
      swing_mode: []
    vertical_vane_select:
      name: ${name} Vertical Vane

    # ESP32 only - change UART0 to UART1 or UART2 and remove the
    # logging:baud_rate above to allow the built-in UART0 to function for
    # logging.
    #hardware_uart: UART2

uart:
  id: HP_UART
  baud_rate: 2400
  tx_pin: GPIO17
  rx_pin: GPIO16